How to Fix Unimac Washer Error Codes

When the NF error code appears, it means that the unit is not filling up with water. Fortunately, this is a relatively simple repair. The first step is to consult your washer’s manual and learn more about the parts. Once you understand what your washer is made of, you can proceed to repair it.

NF stands for “no fill” in unimac washer error codes

The “NF” error code appears when the washer is unable to fill with water. It usually occurs after a washing cycle has been running for 15 minutes without filling. The causes of this error are usually simple and can be solved quickly. You can try cleaning the water inlet filter or replacing the filter if necessary.

The main cause for this error code is that the water supply lines or hoses may have frozen. A faulty solenoid could be causing the problem. Solenoids are electrical devices that send voltage to the inlet valve to open and allow water into the tub. Over time, these coils can wear out and need replacement.

If you notice that your washer does not fill with water, you can clear the error by performing a power cycle on your machine. This will clear any false error codes your washer may have displayed. However, if you continue to receive NF error codes, contact your manufacturer immediately.

How to fix unimac washer error codes

There are several ways to fix an error code on your Unimac washing machine. You should first look at the user manual to see if you can find the problem. Then, you should understand the different components of your washer. If you’re able to figure out what’s causing the error code, you can fix it right away.

If the F/H symbol is displayed, there’s no water coming into the washing machine or very little water is coming in. The cause of this error code is most likely a clogged inlet water valve or a dirty screen. Check the hoses and pressure switch to make sure they’re not blocked.

Common parts of unimac washers

UniMac washers have a range of parts that are easily accessible online. Depending on your model, you may need to replace motor bearings, belts, microswitches, hot water valves, blow fuses, solenoids, moment switches, mesh filters, and other parts. To avoid replacing these parts yourself, it is a good idea to consult a professional.

You may want to seek out parts that are specifically made for Unimac washers. These parts are made to withstand the rigors of commercial front load washing. They are backed by a warranty and are guaranteed to give you a satisfactory solution for your Unimac commercial front load washer.

Repair options for unimac washers

If your Unimac washer is displaying error codes, the first step you should take is to check for a leak. If you see a leak, make sure you tighten the hose connection. Try running a small cold or hot wash in order to see if the water fills up. If the water doesn’t fill up, you may need to replace both valves.